Swap ATH to XMR in three steps without creating an account. You see an estimated amount before you send, the exchange runs automatically once your deposit confirms, and the XMR goes straight to the wallet address you enter.
Enter the amount of Aethir you want to swap in the widget above. It shows an estimate of the Monero you will receive on the Monero network at the current floating rate, with the payout network fee already taken into account.
Paste your XMR wallet address and check it twice, because blockchain transfers cannot be reversed. If the coin needs a memo or destination tag, a field for it appears. xswap.to never asks for your private keys.
Confirm the order and send your ATH to the one-time deposit address on the Ethereum network. Once the deposit confirms, the swap runs automatically and the XMR is sent to your wallet. The order page shows every stage.
Swapping Aethir (ATH) for Monero (XMR) here takes one transfer from your wallet: no exchange account, no balance to deposit and no withdrawal queue. You choose the receiving address, and the XMR goes there once the swap completes.
Rates are floating, so the amount shown is an estimate that can shift slightly while your Aethir deposit confirms on Ethereum. The payout is sent on Monero, so check that your Monero address belongs to that network before you confirm.
Refreshed hourly. The widget shows the live estimate.
2720 ATH
≈
0.0119684 XMR
At the latest hourly update, 2720 ATH converts to about 0.0119684 XMR. The figure comes from the floating rate and already allows for the payout network fee. Rates move, so the widget recalculates the estimate when you enter your own amount, and no account or registration is needed to swap.
ATH token contract:
0xbe0ed4138121ecfc5c0e56b40517da27e6c5226b
Approximate exchange rates between these assets, refreshed hourly
Aethir (ATH) leaves your Ethereum wallet as an ERC-20 token, and Monero (XMR) arrives at a Monero address you control. It takes no account and no ID upload to start. One reason to swap ATH to XMR: you hold ATH and want part of it in a coin whose transfers do not show amounts or addresses on the chain, unlike the public Ethereum record of every ATH transfer.
Behind ATH is a distributed cloud of GPUs rented out for AI and gaming workloads, and the token lives at contract 0xbe0ed4138121ecfc5c0e56b40517da27e6c5226b. Monero hides sender, receiver and amount using ring signatures, stealth addresses and RingCT. Ethereum to Monero is a cross-chain swap, and the ATH transfer needs ETH for gas, since an ERC-20 token cannot pay its own fee. Your payout address is 95 characters long and starts with 4 or 8, and Monero uses no payment ID here.
Price moves matter on this pair: the widget gives a floating-rate estimate in XMR, net of the exchange margin and the Monero network fee for sending your coins, and the final amount can drift slightly if ATH or XMR moves before your deposit confirms. Ethereum adds a block every 12 seconds, and Monero targets one about every two minutes. Your wallet then keeps new XMR locked for a short run of blocks before it can be spent. The order page shows every status and the transaction ID.
From live exchange data, refreshed hourly.
| You send | You receive | |
|---|---|---|
| Asset | Aethir (ATH) | Monero (XMR) |
| Network | Ethereum | Monero |
| Type | ERC-20 token | Native coin |
| Contract | 0xbe0ed4…c5226b |
- |
| Memo / tag | Not needed | Not needed |
| Network fee (checked Nov 7, 2026) | ≈ 69.94 ATH | ≈ 0.009 XMR |
| Route | Cross-chain: Ethereum to Monero | |
| Rate | Floating, estimate shown before you send | |
| Minimum to send | 2589.6896091 ATH | |
| Account / ID | Not needed to start a swap | |
Only the ATH half is visible: anyone can see your Ethereum address send ATH to the deposit address on Etherscan. The Monero payout is different, because Monero hides the receiving address and the amount on its chain. xswap.to does not ask for ID, although in rare cases the exchange partner's compliance check can pause a swap and ask for verification.
Yes, a little ETH has to sit in the wallet that sends the ATH, because Ethereum charges gas in ETH for every ERC-20 transfer. You do not need any XMR beforehand to receive the payout. The Monero fee for sending your XMR is already deducted in the estimate.
Monero keeps newly received coins locked for a short run of blocks before a wallet lets you spend them. This is a protocol rule, not a hold placed by xswap.to, and it applies to every incoming XMR transfer. Your wallet lists the amount as locked or pending until those blocks pass.
Use a standard address starting with 4 or a subaddress starting with 8, both 95 characters long, copied from a Monero wallet you control. A new subaddress keeps this payout apart from your other incoming funds. Monero needs no payment ID here, so the form asks only for the address.
The rate floats until your ATH deposit confirms on Ethereum, so price moves in either coin during that window show up in the result. The estimate already had the exchange margin and the Monero payout fee taken out, so neither is charged again. Gas for the ATH transfer is separate and comes out of your ETH balance.
Start with the order page: if it says finished, the XMR has been sent, and your Monero wallet may still be syncing or holding the coins as locked. If the order looks stuck, message @xswap_to on Telegram with the transaction ID from that page. Support reviews problems case by case, and transfers already on chain cannot be reversed.
