Swap USDT to USDT in three steps without creating an account. You see an estimated amount before you send, the exchange runs automatically once your deposit confirms, and the USDT goes straight to the wallet address you enter.
Enter the amount of Tether (Arbitrum One) you want to swap in the widget above. It shows an estimate of the Tether (ERC20) you will receive on the Ethereum network at the current floating rate, with the payout network fee already taken into account.
Paste your USDT wallet address and check it twice, because blockchain transfers cannot be reversed. If the coin needs a memo or destination tag, a field for it appears. xswap.to never asks for your private keys.
Confirm the order and send your USDT to the one-time deposit address on the Arbitrum One network. Once the deposit confirms, the swap runs automatically and the USDT is sent to your wallet. The order page shows every stage.
Swapping Tether (Arbitrum One) (USDT) for Tether (ERC20) (USDT) here takes one transfer from your wallet: no exchange account, no balance to deposit and no withdrawal queue. You choose the receiving address, and the USDT goes there once the swap completes.
Rates are floating, so the amount shown is an estimate that can shift slightly while your Tether (Arbitrum One) deposit confirms on Arbitrum One. The payout is sent on Ethereum, so check that your Tether (ERC20) address belongs to that network before you confirm.
Refreshed hourly. The widget shows the live estimate.
1 USDT
≈
0.67467 USDT
At the latest hourly update, 1 USDT converts to about 0.67467 USDT. The figure comes from the floating rate and already allows for the payout network fee. Rates move, so the widget recalculates the estimate when you enter your own amount, and no account or registration is needed to swap.
USDT token contract:
0xFd086bC7CD5C481DCC9C85ebE478A1C0b69FCbb9
USDT token contract:
0xdAC17F958D2ee523a2206206994597C13D831ec7
Approximate exchange rates between these assets, refreshed hourly
As of Nov 10, 2026 19:26 UTC, 1 USDT is worth about $1.00 and 1 USDT about $1.00, so 1 USDT converts to roughly 0.67467 USDT. These figures move with the market, and the widget shows the live estimate before you confirm.
Here USDT leaves Arbitrum One and arrives on Ethereum mainnet as Tether's ERC-20 token, at the 0x address you type in, with no account and no ID upload to start. A common case: you closed a position or left a lending pool on Arbitrum, and the account you want to fund, perhaps an exchange or an OTC desk, accepts USDT on Ethereum but not on Arbitrum One. Moving USDT from Arbitrum to ERC-20 here takes one deposit and one payout.
Arbitrum One is an optimistic rollup that settles its batches on Ethereum and charges gas in ETH, so your deposit needs ETH held on Arbitrum, not on mainnet. Since early 2025 its USDT contract, 0xFd086bC7CD5C481DCC9C85ebE478A1C0b69FCbb9, carries USDT0, which is why some wallets show that name. The payout is the ERC-20 token at 0xdAC17F958D2ee523a2206206994597C13D831ec7. Both networks use identical 0x addresses and no memo, and only your network choice tells them apart.
Expect an estimate a little under what you send. The rate between the two USDT listings floats near parity, and the cost is mainly the Arbitrum deposit fee plus the Ethereum payout fee, both already in the estimate and listed in the at-a-glance table. The figure can shift slightly before your deposit confirms. Arbitrum One produces blocks far more often than Ethereum, which adds one every 12 seconds, so mainnet gas demand matters most for the payout. Follow each stage on the order page.
From live exchange data, refreshed hourly.
| You send | You receive | |
|---|---|---|
| Asset | Tether (Arbitrum One) (USDT) | Tether (ERC20) (USDT) |
| Network | Arbitrum One | Ethereum |
| Type | ERC-20 token | ERC-20 token |
| Contract | 0xFd086b…9FCbb9 |
0xdAC17F…831ec7 |
| Memo / tag | Not needed | Not needed |
| Network fee (checked Nov 7, 2026) | ≈ 0.1555 USDT | ≈ 0.3712 USDT |
| Route | Cross-chain: Arbitrum One to Ethereum | |
| Rate | Floating, estimate shown before you send | |
| Minimum to send | 0.683808 USDT | |
| Account / ID | Not needed to start a swap | |
It is, as long as the contract is 0xFd086bC7CD5C481DCC9C85ebE478A1C0b69FCbb9. In early 2025 the bridged USDT on Arbitrum One was upgraded to USDT0 at that address, and existing balances converted automatically. Select the Tether (Arbitrum One) listing and send from Arbitrum One.
On Arbitrum One. The deposit is an Arbitrum transaction, so its gas comes from ETH held on Arbitrum, and ETH sitting on mainnet cannot pay it. Receiving the ERC-20 payout costs you nothing, but moving that USDT later on mainnet needs ETH there.
It lands on Ethereum at the same-looking 0x address, which is not the network this order watches, so the swap does not start. A sent transaction cannot be reversed from your side. Contact @xswap_to on Telegram with the transaction ID and order details, and support will look at what can be done.
Each side has its own block explorer. Your deposit shows on Arbiscan under the hash from your wallet, and the payout shows on Etherscan once the order page lists its hash. If Etherscan shows the payout but your wallet does not, switch the wallet to Ethereum mainnet.
No, the deposit address only accepts USDT on Arbitrum One. USDT on another network, such as OP Mainnet or Polygon PoS, needs its own listing chosen in the coin selector before you create the order. Arbitrum Nova is a different chain from Arbitrum One, even though the addresses look identical.
No account and no ID upload are needed to start: you give an Ethereum address, send USDT on Arbitrum One to the deposit address, and the payout follows. In rare cases the exchange partner's compliance check can pause a swap and ask for verification. xswap.to never asks for private keys or a seed phrase.
