Swap USDT to USDT in three steps without creating an account. You see an estimated amount before you send, the exchange runs automatically once your deposit confirms, and the USDT goes straight to the wallet address you enter.
Enter the amount of Tether (TRC20) you want to swap in the widget above. It shows an estimate of the Tether USD (TON) you will receive on the TON network at the current floating rate, with the payout network fee already taken into account.
Paste your USDT wallet address and check it twice, because blockchain transfers cannot be reversed. If the coin needs a memo or destination tag, a field for it appears. xswap.to never asks for your private keys.
Confirm the order and send your USDT to the one-time deposit address on the TRON network. Once the deposit confirms, the swap runs automatically and the USDT is sent to your wallet. The order page shows every stage.
Swapping Tether (TRC20) (USDT) for Tether USD (TON) (USDT) here takes one transfer from your wallet: no exchange account, no balance to deposit and no withdrawal queue. You choose the receiving address, and the USDT goes there once the swap completes.
Rates are floating, so the amount shown is an estimate that can shift slightly while your Tether (TRC20) deposit confirms on TRON. The payout is sent on TON, so check that your Tether USD (TON) address belongs to that network before you confirm.
Refreshed hourly. The widget shows the live estimate.
13 USDT
≈
7.643515 USDT
At the latest hourly update, 13 USDT converts to about 7.643515 USDT. The figure comes from the floating rate and already allows for the payout network fee. Rates move, so the widget recalculates the estimate when you enter your own amount, and no account or registration is needed to swap.
USDT token contract:
TR7NHqjeKQxGTCi8q8ZY4pL8otSzgjLj6t
USDT token contract:
EQCxE6mUtQJKFnGfaROTKOt1lZbDiiX1kCixRv7Nw2Id_sDs
Approximate exchange rates between these assets, refreshed hourly
As of Nov 10, 2026 19:03 UTC, 1 USDT is worth about $1.00 and 1 USDT about $1.00, so 1 USDT converts to roughly 0.587963 USDT. These figures move with the market, and the widget shows the live estimate before you confirm.
TRC-20 Tether (USDT) leaves your TRON wallet and lands as the USDT Jetton on TON, at a TON address you enter, with no account and no ID upload to start. Typical reasons to move USDT from TRON to TON: you want the dollars in a TON wallet you open from Telegram, you are paying in a TON app, or the person you owe only has a TON address. Moving USDT on TON also tends to cost less gas than a TRC-20 transfer, which usually burns TRX for energy.
On TRON, USDT is Tether's TRC-20 token at TR7NHqjeKQxGTCi8q8ZY4pL8otSzgjLj6t, and sending it uses energy and bandwidth, paid for with TRX. On TON, Tether's Jetton master is EQCxE6mUtQJKFnGfaROTKOt1lZbDiiX1kCixRv7Nw2Id_sDs, and payouts go to a 48-character address that usually starts with UQ or EQ. The form shows a memo field for TON: fill it in only when an exchange or custodial service gave you a memo or comment, and leave it empty for a self-custody wallet such as Tonkeeper.
Same stablecoin, two networks: the floating-rate estimate lands close to one to one, and the difference is mostly a deposit fee taken from your TRC-20 USDT plus the TON payout fee, both shown in the at-a-glance table and already in the estimate. Flat network fees eat into small amounts, so compare them before sending. The final figure can move slightly before your TRON deposit confirms. TRON makes a block about every 3 seconds, and the order page shows each step.
From live exchange data, refreshed hourly.
| You send | You receive | |
|---|---|---|
| Asset | Tether (TRC20) (USDT) | Tether USD (TON) (USDT) |
| Network | TRON | TON |
| Type | TRC-20 token | Jetton token |
| Contract | TR7NHqje…gjLj6t |
EQCxE6mU…Id_sDs |
| Memo / tag | Not needed | Required with your address |
| Network fee (checked Nov 7, 2026) | ≈ 5.171 USDT | ≈ 0.06559 USDT |
| Route | Cross-chain: TRON to TON | |
| Rate | Floating, estimate shown before you send | |
| Minimum to send | 11.482802 USDT | |
| Account / ID | Not needed to start a swap | |
Only when the TON address belongs to an exchange or custodial service that asked for a memo or comment, since that is how it credits your account. A self-custody wallet such as Tonkeeper or MyTonWallet needs none, so leave the field empty. A missing memo at an exchange can leave the USDT uncredited until its support traces the transfer.
A TRC-20 transfer to an address that has never held USDT, which a new deposit address may be, uses more energy than a transfer to an address that already holds it. Without staked energy, your wallet burns TRX to cover that. Top up first, since a transfer that runs out of energy fails and still costs the TRX it used.
A TON address in the usual user-friendly form has 48 characters and mostly starts with UQ or EQ, two forms of the same account. A TRON address has 34 characters and starts with T. This payout needs the TON kind, and a T address in that field points to the wrong network.
Both are issued by Tether and track the US dollar, but they are separate tokens on separate chains, each with its own contract. A balance on TRON cannot be sent to a TON address directly, which is why you deposit TRC-20 USDT and receive a new Jetton transfer on TON.
Look up your TON address on an explorer such as Tonviewer and check for Tether USD from the Jetton master EQCxE6mUtQJKFnGfaROTKOt1lZbDiiX1kCixRv7Nw2Id_sDs. If the transfer is listed there, the USDT is at your address even if the wallet has not refreshed yet. If the order page has not reached finished, the swap is still in progress, and @xswap_to can check it with the transaction ID.
You can: there is no account and no ID upload to start. You enter the TON address, send TRC-20 USDT to the deposit address and follow the order page, and xswap.to never asks for keys or a seed phrase. In rare cases the exchange partner's compliance check can pause a swap and ask for verification.
